![]() ![]() Find the best Wi-Fi 6 routers for advanced wireless connections.WiFi and GSM Routers with 4g and 5g LTE cat 20, cat 12, cat 6, cat 4 support - LTE gateways. It’s best to get a Wi-Fi router with at least 802. We do not see the justification for paying £450 or more for a single Wi-Fi device, particularly given the erratic performance of early Wi-Fi 6 802. Some Wi-Fi mesh systems even offer a 6 GHz band that can handle and exceed gigabit speeds. ![]() (You could do throttling on the DD-WRT WAP - DD-WRT has some QoS functionality - but it wouldn't know about wired traffic on the internal network, so would be limited in the scope of QoS/traffic prioritization it could enforce.Best openwrt router wifi 6. With either solution you'll want some QoS/throttling too, probably on your OpenBSD box. Just a SMoC (simple matter of configuration). ![]() You'll need to set up DHCP on each VLAN's subnet, presumably on OpenBSD (or you could use the AP to provide DHCP for the "guest" subnet, I guess). Configure OpenBSD with the same VLANs/tags and set up pf rules as needed.Įach VLAN will be in a different subnet (e.g. So you could use DD-WRT/OpenWRT on your AP/wireless bridge and set up a VWLAN for the "guest" wifi, bridged to a corresponding VLAN, plus the normal WLAN bridged to the normal VLAN, with 802.1q tagging on the "LAN/WAN" port (which is in both VLANs) that connects the AP to the OpenBSD router. I don't know OpenBSD but it almost certainly supports VLANs and 802.1q VLAN trunking. I assume you want to keep OpenBSD as your gateway router. Most consumer/SOHO routers won't expose such features in their stock firmware, of course. ĭD-WRT also supports 802.1q VLAN trunking, which allows traffic from multiple VLANs to share a single ethernet port/cable/NIC - although the support for this depends on the specific chipset/board/device: see the previous link. To set the DHCP on the V(W)LANs and the ipfilter rules for the traffic allowed between the VLANs and the WAN (or between the different VLANs) you need to use the "startup commands" rather than doing it all through the admin WebUI. But if you don't want to spend any money, or are doing this more to learn than anything else then.ĭD-WRT support VLANs (virtual LANs) and VWLANs (virtual wireless LANs), and can have separate DHCP on the different VLANs. The "simple" way is an extra NIC in your OpenBSD router and a second AP, which is probably $50 outlay. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |